is a plug-and-play expansion board designed to simplify the connection of sensors, servos, and modules to microcontrollers like the Arduino Uno or Mega 2560 . It eliminates the need for breadboards by organizing I/O pins into standardized 3-pin headers consisting of , Voltage (VCC) , and Ground (G) . Technical Specifications Compatible Boards Arduino Uno, Mega, Leonardo Digital I/O Ports 13 (D0–D13) with dedicated VCC and GND Analog I/O Ports 6 (A0–A5) with dedicated VCC and GND Communication I2C, SPI, UART (Serial), Bluetooth, APC220 Special Interfaces SD Card, Ultrasonic (URF), LCD (Serial & Parallel) Dimensions 57mm x 57mm Key Features and Interfaces Shields & Carriers - Arduino Store
: 5V DC and 3.3V DC (drawn from the Arduino board) arduino sensor shield v5 0 manual
Connect an external 5V to 6V power supply (such as a 4AA battery pack or a dedicated wall adapter) to the . is a plug-and-play expansion board designed to simplify
delay(100);
Even with a user-friendly shield, you might run into issues. Here are the most common fixes: delay(100); Even with a user-friendly shield, you might
: Features a remote reset button for easier access when the shield is stacked. Power Configuration (The SEL Jumper)
Open the Arduino IDE and upload a simple “Blink” sketch (which uses pin 13). The yellow LED labelled “L” on the shield (connected to D13) should start blinking. This confirms that the shield is passing signals and power correctly.