--- Epcos Power Factor Controller Br 5016 Manual Pdf Jun 2026

Verify that the CT is on Phase L1 and voltage inputs are connected to L2 and L3. Reverse CT polarity if necessary.

The controller measures Total Harmonic Distortion for voltage. If THD limits are exceeded, it trips the steps to prevent capacitor overheating.

Slide the included mounting brackets into the side slots and tighten the screws firmly against the panel door. Terminal Connections and Wiring --- Epcos Power Factor Controller Br 5016 Manual Pdf

The EPCOS BR5016 (often branded under TDK-Epcos) is a digital power factor controller used in electrical engineering to optimize energy efficiency in industrial power grids. It regulates the connection and disconnection of capacitor banks to correct the power factor (cos φ), reducing reactive power consumption and avoiding penalties from utility companies.

Before installing or programming the BR5016, verify that your system architecture aligns with the technical limits of the device. 110 V to 230 V AC (±10%), 50/60 Hz. Measurement Voltage: 30 V to 525 V AC (L-L or L-N). Current Input: X/5A or X/1A (configurable via CT ratio). Verify that the CT is on Phase L1

: The safety delay required before a capacitor can be switched back on. 3. Manual Mode

The Epcos BR5016 is a micro-processor-controlled power factor controller designed for three-phase power systems. It measures the phase shift between voltage and current, calculating the reactive power required to achieve a user-defined target power factor ( If THD limits are exceeded, it trips the

Increase the switching time delay parameter and verify that the step sizes programmed match the actual physical capacitor values.